Some of my build notes re the fader bank.
This is a eurorack compatible module, however it does use midi and i2c so I hope it is compatible with other synths.
The official website is here:
https://16n-faderbank.github.io/
You can make your own PCBs and panels for it.
Github
https://github.com/16n-faderbank/16n/tree/master/electronics
The module uses a teensy microcontroller
The official build notes are here:
https://github.com/16n-faderbank/16n/tree/master/build
cd 4067
This is a cmos 16 channel multiplexer
MCP6004
This is a quad op-amp
diodes:
+ If you plan on using I2C with an ER-301,
Ansible or TXo, (ie I2C "MASTER" mode) you should populate the 4.7K resistors.
+ If you plan on using I2C with a monome Teletype,
do not populate these resistors - it may well cause problems.
........................ I'll leave these off for the moment... see how it goes
the stereo jack sockets for MIDI and I2C.
the 16 mono jacks.
tHE Teensy 3.2
to be continued ... waiting for some parts
This is a eurorack compatible module, however it does use midi and i2c so I hope it is compatible with other synths.
The official website is here:
https://16n-faderbank.github.io/
You can make your own PCBs and panels for it.
Github
https://github.com/16n-faderbank/16n/tree/master/electronics
The module uses a teensy microcontroller
The official build notes are here:
https://github.com/16n-faderbank/16n/tree/master/build
cd 4067
This is a cmos 16 channel multiplexer
MCP6004
This is a quad op-amp
diodes:
D1 to D4 are four SOD-123 diodes.R17 and R18 are 4.7k resistors.+ If you plan on using I2C with an ER-301,
Ansible or TXo, (ie I2C "MASTER" mode) you should populate the 4.7K resistors.
+ If you plan on using I2C with a monome Teletype,
do not populate these resistors - it may well cause problems.
........................ I'll leave these off for the moment... see how it goes
the stereo jack sockets for MIDI and I2C.
the 16 mono jacks.
tHE Teensy 3.2
