Lyra 8 build - part 2

Part two of the Lyra 8 Build
Part 1 can be found here:
 + Lyra 8 build - part 1 

Finally getting around to finishing the build of the Soma Labs Lyra 8
My apologies for the delay.

This is where I left off:
 mANY thanks to Gareth of Oscillosaurus for supplying the faceplate.




The SMD ICs


with SMD ICs if there isn't a dot or a notch, then the pin-1 side will be beveled

Capacitors
The BOM uses unfamilar units
1m = 1uF




tHE cathode (-ve) corresponds with the black line



Using 25mm standoffs



The face plate must be non conductive .
That way, the PCB can sit flush against the faceplate.



tHE Pots

*there are 10 x  c100k mono pots ant log curve.for the 8 tunes & hyper LFO A & B






*There are 4 stereo C100k, anti log curve
Used in the 4 MOD pots





*there are 4 A100K stereo log curve pots
These are dual
These are used in the four sharp knobs



* three A100K , mono log
Time 1, Time 2 (Mod Delay) , Drive (distortion)



* five A50k mono log
 two holds, two mods, and volume.



* five B50K, mono linear
FB, Mix (mod delay), MIX distortion, Pitch x 2

The Switches
MTS 202
MTS 203
MTS 103
MTS 102


MTS 202



Links
Muffs

To be continued......................................